Table of Contents
Advertisement
9 Configuration
Use the Setup screens to fine-tune the LED heads, configure the irradiation patterns, etc.
Do display the Setup screen, touch MENU → SETTING. Touch the buttons below to display their
corresponding Setup screens.
9.1 Fine Tuning the LED Head
Head adjust: Fine-tune the LED head
Pattern: Configure the irradiation patterns
Busy signal: Change the busy-signal output contact
Switch Language: Switch the UI language
Menu: Hold down for 5 seconds to return to INTERLOCK → MENU
Lock on:
Lock off: MENU
INTERLOCK
1. Type selection（10）
2. Type setup data (10)
3. Pattern setup data (10)
4. LED 1 to 4 cumulative data (irrad. period, irrad. times)
To display the Fine Tune LED Head screen, touch MENU → SETTING
→ HEAD ADJ.
When irradiation is enabled, you can measure the intensity while
pressing the EMISSION button on the main unit to perform irradiation,
and fine-tune the LED head in accordance with the required
light-modulation ratio. It is possible to simply enter an intensity, without
performing irradiation.
1
Touch the plus and minus (+/–) keys to fine-tune the LED
head.
The number of steps appears.
Touch C to clear.
READY: Displays the main-unit status.
100%: The light modulation ratio. Touch to adjust the light
modulation ratio.
Setting the light modulation ratio
Enter a number by touching 0 to 9, then touch the Enter
button ( ↵ ). See page 18 for the actions of the other keys.
2
Press and hold MEMORY until the display is inverted.
The settings are saved.
3
Touch the down arrow (↓) to configure the next LED head.
4
Press BACK to return to the Setup screen.
MENU
5. Start signal (pulse/status)
6. Irradiation setup（indiv./batch）
7. LED head fine adjustment (4)
8. BUSY signal (for a/b)
23
Advertisement
Table of Contents
