Table of Contents
Advertisement
Batch Setup/Batch Control
(Main Menu > Batch)
Batch is a firmware option which can be activated from
The Batch function allows the user to segment portions of data for further analysis. Setting
up a batch requires information to identify where the batch starts and stops. Batch data can
also be paused, for viewing, and resumed. A batch can be aborted at any time, if so this will
not register as a batch, a batch is only complete when it has been stopped.
Only one batch can be run at a time, stop the first batch before starting a new one. To start
a batch enter information in all the required screens that have previously set up in the
"Batch Menu" on page
The default field names are:
The field names can be changed in the
If Allow Direct Access has been setup in the
Reader can be used to make entries for all the items listed in this menu.
for Batch" on page 119.
Press the Finish button if all the Batch details are correct and you wish to start the batch
immediately. Use the Back button to return to the Batch setup and not start the batch.
43-TV-25-35 GLO Iss.4 Dec 06 UK
A5E01001767-04
Power up
97.
• Batch Name - Name to Identify the batch
• User ID - Identification of user starting the batch. If Passwords are active on the
recorder then the User ID page will be skipped for user entry and will be automatically
entered.
• Lot.No - Add a batch Lot No., if required
• Desc - Enter a description of what the batch is
• Comment - Add any further comments
Figure 4.14 Batch Setup screens
"Credits" on page
"Batch Menu" on page 97.
"Batch Menu" on page 97
92.
then a Barcode
See "Barcodes
117
Advertisement
Table of Contents
