Advertisement
CHAPTER 1 - INTRODUCTION
[6]
Italian Decree Law 25 November 1996, n° 626 "Actuation of the directive 93/68/EEC
related to CE mark of electric material intended to be used within certain voltage Limits".
Reference documents
[7]
Standard lEC_CENELEC EN 60204-1, class. IEC 44-5 "Safety of machinery. Electric
equipment of machines. Part 1: General rules".
[8]
Standard CENELEC EN 61800-3: "Adjustable speed electrical power drive systems
Part 3: EMC product standard including specific test methods".
Documents [7] and [8] contain very detailed lists of standard references.
[9]
Standard CENELEC EN60034-1 "Rotating Electric Machines. Part 1: Nominal and
operating characteristics".
[10] Standard CENELEC EN60034-5 "Rotating Electric Machines. Part 5: Classification of
the protection degrees of the cases of electric rotating machines".
[11] Standard CENELEC EN60034-7 "Rotating Electric Machines. Part 7: Classification of
construction forms and of types of installation".
[12] Standard CENELEC EN60034-9 "Rotating Electric Machines. Part 9: Noise limits".
[13] Standard CENELEC EN60034-18-1 "Rotating Electric Machines. Part 18: Functional
evaluations of insulation systems - Section 1: general directives".
1.4 Compliance with the EMC Directives and
1.4.1 Conditions for the compliance with the EMC directives of the drives made up of
servomotors SERIES 8 and convertors SERIES BHL-D.
The compliance of the drives defined in the title of this paragraphwith directives [1], [2], [3] on
Electro Magnetic Compatibility is valid only under the conditions listed below.
1.4.1.1
Drives defined in the title of this paragraph are commercialized only as PDS and in restricted
distribution (see paragraph 1.2.11); therefore the manufacturer of the cabinet and/or the
technician in charge of the installation and/or the end user are competent in EMC field.
1.4.1.2
Drives defined in the title of this paragraph must be installed according to the instructions
contained in Chapter 3 of this manual, in particular prescriptions in paragraph 3.3
"Guidelines on the application of Electro Magnetic Compatibility" must rigorously be
followed.
1.4.1.3
Drives defined in the title of this paragraph are components, sold to be included as part of an
apparatus or system or installation; therefore the operating conditions of the PDS inside the
apparatus, system or installation must be as prescribed in Chapter 3 of this manual.
1.4.1.4
Drives defined in the title of this paragraph must be intended only to be used in the "Second
Environment" (see paragraph 1.2.13).
MANIU04.9607 GB 03/97
mark
Page 1.5
Advertisement
