Advertisement
CHAPTER 1 - INTRODUCTION
1.4.2 Compliance of the drives defined in the title of this paragraph with the EMC directives
[1], [2] and [3] and with the Low Voltage Directive [4], [5] and [6]
ABB Servomotors declares that, under the conditions specified in this document, in particular
in paragraph 1.4, drives made up of servomotors SERIES 8 and convertors series BHL-D
are in conformity with the EMC EEC Directives [1], including the latest amendments, with the
related Italian laws of approximation, [2] and [3], and with the Low Voltage Community
Directives [4], [5] and [6]; the applicable standards can be seen in paragraph 1.3.3.
1.4.3 Notes.for the application of other EEC directives
Drives, being electric components, are not subjected to other EEC directives, beside those
indicated in paragraph 1.3. However, for application reasons, there are references in other
directives in particular, to comply with the requirements of article 4 of the Machine Directive
89/392 EEC and further amendments 91/368 EEC, 93/44 EEC, 93/68 EEC, ltalian law of
approximation D.P.R. n° 459 dtd 24/07/1996, we include the manufacturer's declaration
(also known as Declaration of Incorporation").
In order to comply with the Machine Directive (MD) 89/392/EEC and further amendments,
ABB Servomotors declares that drives made up of servomotors SERIES 8 and convertors
series BHL-D must be installed according to its instructions and must not be started-up until
the machinery into which they are to be incorporated has been found and declared to be in
conformity with a.m. MD directive.
1. 5 Symbols related to safety
In this edition the following symbols are used:
1.5.1
WARNING !
This symbol draws attention to a situation that may be (even seriously)
dangerous for people or that may provoke serious damages to the apparatus
or the system driven. This is the most important alarm level. lt is absolutely
necessary to follow the instructions signaled with symbols 1.5.2 and 1.5.3!
1.5.2
WARNING ! Dangerous voltage: it signals dangerous situations as described
in 1.5.1, due to electric voltages.
1.5.3
WARNING ! Generic danger: it signals dangerous situations as described in
1.5.1, due to other causes than electric voltage.
1.5.4
CAUTION This symbol is used to signal a level of danger lower than the one indicated by
"WARNING!". The situations signaled by this symbol may bring to minor
damages both for people and for machinery.
MANIU04.9607 GB 03/97
Declaration of conformity
Manufacturer's Declaration
Page 1.6
Advertisement
