Figure 20. Extending the RPM Ejector Levers
2.
Hold the card assembly by the metal carrier edges. Avoid touching the printed circuit board and
connector pins.
3.
The arrow in RPM slot 0 (item 2 in Figure 20) identifies the slot in which you must insert the first RPM.
Align the card with the guide (item 2 in Figure 20) and gently slide it into the slot by holding the two
ejector levers in the fully open position and pushing the card forward. You should feel the backplane
connectors on the RPM engage with the chassis backplane.
26
Installing the Hardware