Figure 32. Console Ports on Route Processor Module
1.
USB-B console port
Setting RJ45 Console Access
The RJ45 console port is an asynchronous serial port. If you connect a console to this port, it must
support asynchronous transmission.
NOTE: Before connecting a console, be sure that a terminal emulation program is already installed
on your PC console.
1.
Install an RJ-45 copper cable into the console port. To connect the C9010 console port to a
terminal server, use a rollover cable.
2.
Connect the other end of the cable to the DTE terminal server.
3.
Set your terminal or terminal emulation mode to VT100 with the following settings:
•
9600 baud rate
•
No parity
•
8 data bits
•
1 stop bit
•
Window Terminal Emulator option set to NO
•
24 lines x 80 characters
•
No flow control
RJ45 Cable and Adapter Pin Assignments
To configure and monitor your system, you can connect to a terminal port, PC serial port, or a terminal
server by using the RJ45 console port on the RPM. An RJ-45 Ethernet cable is required to connect to the
Ethernet port.
The following table describes the pinouts for the RJ-45 console port.
Table 7. Pin Assignments for the RJ-45 Console Port
Pin
Serial
1
NC (unused)
2
DTR
3
TxD
Configuring the Software
2.
Input/Output
-
Output
Output
RJ45 console port
41