Baking Bread - Silvercrest SBB 850 C1 Operating Instructions Manual

WARNING! RISK OF FIRE!
► Never use quantities greater than those speci-
fied . If there is too much dough, some could
spill over the baking mould 7, drop onto the
hot heating elements and cause a fire .
■ Ensure that you measure the ingredients precisely .
Even small deviations from the quantities specified
in the recipe may affect the baking results .

Baking bread

Preparation
NOTE
► Place the bread maker on a level and firm
surface .
1) Pull the baking mould 7 upwards and out of
the appliance .
2) Push the kneading blades 6 onto the drive
shafts in the baking mould 7 . Ensure that they
are firmly seated .
3) Add the ingredients into the baking mould 7 .
First add the liquids, sugar and salt, then the
flour . Add the yeast as the last ingredient .
NOTE
► Ensure that the yeast does not come into
contact with salt or liquids .
4) Insert the baking mould 7 again . Ensure that it
clicks into place correctly .
5) Close the appliance lid 2 .
6) Put the power plug into the mains power socket .
You will hear a beep and the programme
number and the duration for programme 1
will appear on the display A .
7) Select the programme you want using the
programme select button G . Every input is
acknowledged with a beep .
8) If necessary, use button F to select the size
of bread you want to bake .
SBB 850 C1
9) Select the required level of browning C for
your bread . The arrow on the display A shows
you if you have selected, light, medium or dark .
Here you can also select the setting "Super
Rapid" to shorten the time during which the
dough rises .
NOTE
► A browning level cannot be selected for
programmes 6, 7 and 11 .
The function "Rapid" is only available for
programmes 1–4 .
A bread weight cannot be selected for pro-
grammes 6, 7, 11 and 12 .
10) You now have the option of setting the end time
of your programme using the timer function .
You can enter in a maximum time delay of up
to 15 hours .
NOTE
► This function is not available for programme 11 .
Starting a programme
Start the programme with the Start/Stop button B .
NOTE
► Programmes 1, 2, 3, 4, 6 and 8 start with a
10 to 30 minute preheating phase (except
Super Rapid, see table for programme se-
quences) . The kneading blades 6 do not move .
This is not a malfunction of the appliance .
The programme will carry out the various operations
automatically .
NOTE
► For the programmes 1, 2, 3, 4, 5, 8, 9 and
10, you will hear a beep after the "Rise 2"
programme section and "RMV" c appears
on the display A . You can now remove the
kneading blades 6 from the dough . If you do
not want to remove the kneading blades 6,
simply wait . The appliance will automatically
resume the programme .
GB │ MT │ 77 ■