Bacnet - LG PQNFB17C1 Installation & Owner's Manual

INSTALLING ACP BACnet
36
Setting Vnet Number
To use Modbus TCP function of ACP BACnet, Vnet Number must be set.
Set Vnet Number is used to Slave ID Address of Modbus TCP.
Proceed in the following order.
1.
When you press [SET]
of the ACP BACnet to select [Contents], and press [SET] button again. While [Vnet No] is
selected, pressing [SET] button will display the screen to set Vnet Number.
Software service function
The following software service function can be run using the menu of the ACP BACnet.
This function shall only be used by the specialized service technician, and negligent use may cause
failure of the ACP BACnet system.
Software update
Data backup
Data recovery
RS-485 data logging
PQNFB1 PQNFB17C0 NF NFB1 NFB1 NFB1 NFB1 NFB1 FB FB1 FB1 FB1 FB1 F FB FB FB1 FB1 FB1 FB1 B B B 1 B1 B1 1 1 17C0 1 1 1 7C0 7C 7C0 7C0 7C0 C C C C0 C0 C0 C0 C0 C C 0 0 0 0 0 0 0 0 0
Network Info
> Contents
Function
Register FD
Click
[SET]
button
[ Contents 2/2 ]
Device ID
>
Vnet No
Click
[SET]
button
[ Set VNET NO ]
000010
9000
10