Cd-Rom Drive - Siemens SIMATIC PG 720 P Manual

3.6

CD-ROM Drive

Overview
You can use the CD-ROM drive to display information contained on CDs on
the PG 720. The CD-ROM drive is installed at the back of the PG 720. It is
operated on the same port as the hard disk drive.
Opening the Swing the PG 720 into a horizontal position. The CD-ROM drive is now on
Drawer the underside of the programming device. Switch the device on. By briefly
pressing the eject button, the drawer springs out slightly. Now pull the drawer
out until it clicks into position.
Inserting / When you first open the CD-ROM drive, you will find a film sheet in the
Removing CDs
drawer, to protect the drive during transport. Remove this sheet. Now insert
the CD in the drawer with the labeling face up, and press it firmly down into
the center of the turntable. To remove the CD, hold it by the edges and pull
upwards.
Closing the Drawer Push in the drawer until it closes completely. Do not press the eject button.
Note
To avoid too much pressure on the open drawer, always hold the drawer at
the front with one hand when inserting or removing a CD.
The EJECT function offered by various applications for opening the
CD-ROM drawer does not work with this drive.
CD-ROM Front
PG 720 P Programming Device
C79000-G7076-C721-02
2
1 Access display
This display lights up when data are being read.
2 Drawer
This drawer can be opened and closed by hand.
The CD is inserted here.
3 Eject button
This button unlocks the drawer (2) for opening.
4 Emergency eject hole
Getting to Know the PG 720
1 3 4
3-17