ABB Relion 670 Series Applications Manual page 383

1MRK 511 358-UUS A
Latchedx : decides if the command signal for output x is Latched (steady) or Pulsed .
tPulsex : if Latchedx is set to Pulsed , then tPulsex will set the length of the pulse (in seconds).
13.10 AutomationBits, command function for DNP3.0
AUTOBITS
13.10.1 Identification
Function description
AutomationBits, command function
13.10.2 Application
Automation bits, command function for DNP3 (AUTOBITS) is used within PCM600 in order to get
into the configuration the commands coming through the DNP3.0 protocol.The AUTOBITS
function plays the same role as functions GOOSEBINRCV (for IEC 61850) and MULTICMDRCV (for
LON).AUTOBITS function block have 32 individual outputs which each can be mapped as a Binary
Output point in DNP3. The output is operated by a "Object 12" in DNP3. This object contains
parameters for control-code, count, on-time and off-time. To operate an AUTOBITS output point,
send a control-code of latch-On, latch-Off, pulse-On, pulse-Off, Trip or Close. The remaining
parameters are regarded as appropriate. For example, pulse-On, on-time=100, off-time=300,
count=5 would give 5 positive 100 ms pulses, 300 ms apart.
For description of the DNP3 protocol implementation, refer to the Communication manual.
13.10.3 Setting guidelines
AUTOBITS function block has one setting, (
function. These names will be seen in the DNP3 communication management tool in PCM600.
13.11 Single command, 16 signals SINGLECMD
13.11.1 Identification
Function description
Single command, 16 signals
Application manual
IEC 61850
identification
for DNP3
IEC 61850
identification
SINGLECMD
IEC 60617
identification
AUTOBITS -
Operation : Enabled / Disabled ) enabling or disabling the
IEC 60617
identification
-
GUID-C3BB63F5-F0E7-4B00-AF0F-917ECF87B016 v4
ANSI/IEEE C37.2
device number
-
GUID-2217CCC2-5581-407F-A4BC-266CD6808984 v1
ANSI/IEEE C37.2
device number
-
Section 13
Control
SEMOD158589-1 v3
SEMOD158637-5 v4
SEMOD158639-5 v3
SEMOD119849-1 v2
377