Toro LT-F3000 Operator's Manual page 30

Figure 39
1. Hex plug
3. Locate the M12 x 40 mm setscrew and washer
stored underneath the operator platform, one in
each of the platform support rails.
4. Install a M12 x 40 mm long setscrew with washer
into the hole in the center of the motor end plate
(Figure 40).
Figure 40
1. Hex plug
2. Washer M12
5. Tighten the setscrew into the threaded hole
in the brake piston until the brake is released
(Figure 40).
6. Identify the left front wheel motor disc brake
assembly and repeat the previous procedure
(Figure 40).
7. Decommission the hydraulic service braking
system by turning the bypass valve, located
under the transmission pump, counterclockwise,
a maximum of 3 turns
The steering must be operated manually when
the mower is being towed. The steering will feel
g014448
g014449
3. Setscrew M12 x 40
(Figure 41).
heavy as there is no hydraulic assistance when
the engine is shut off.
1. Transmission bypass valves
8. The mower is now in a freewheel condition and
can be towed for a short distance at slow speed.
Note:
Remove the wheel chocks before towing.
9. After towing the mower: To return the mower
to its normal working condition the following
procedure must be done:
A. Chock the front wheels.
B. Close the bypass valve on the transmission
pump by turning it clockwise.
10. Commission the front wheel motor disc
brakes as follows:
Note:
Ensure that the M12 x 40 mm
setscrews and washers are removed and stored
underneath the operator platform.
A. Identify the right front wheel motor disc
brake assembly.
B. Rotate the setscrew counterclockwise and
remove together with the washer.
C. Assemble the hex plug into the motor end
plate (Figure
30
Figure 41
42).
g014450