Drive System
Maintenance
Checking the Tire Pressure
Check the air pressure in the front and rear tires.
Refer to the chart below for the correct pressure.
Important:
Maintain correct tire pressure in all
tires to ensure correct contact with the turf.
Recommended tire pressure is 1 bar (14.5 psi)
for general all around use. Tire pressures can be
adjusted according to the following table depending
on operating conditions.
Tires
Tire Type
Front Axle
26 x
12.0 - 12
BKT turf
pattern
Rear Axle
20 x 10.0 -
8 BKT turf
pattern
Checking the Torque of the
Wheel-Lug Nuts
Service Interval: Before each use or daily
Torque the wheel-lug nuts to 200 N∙m (148 ft-lb) for
the front axle, and 54 N∙m (40 ft-lb) for the rear axle.
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Ensure that the wheel nuts are torqued
properly.
Recommended Tire Pressures
Turf
Road
Maximum
Conditions
Conditions
Pressure
0.7 bar (10
1.4 bar (20
1.7 bar (25
psi)
psi)
0.7 bar (10
1.4 bar (20
1.7 bar (25
psi)
psi)
Changing the Transmission
Oil Filter
Service Interval: After the first 50 hours
Every 500 hours
psi)
psi)
1. Transmission-oil filter
1.
Unscrew and remove the bottom of the
transmission-oil-filter housing.
2.
Withdraw the filter element and discard it.
3.
Install a new filter element.
4.
Install the housing.
Changing the
Hydraulic-Return Filter
Service Interval: After the first 50 hours
Every 500 hours
1.
Remove the return filter.
2.
Wipe oil onto the new return filter gasket.
3.
Install the new return filter to the machine.
42
Figure 52
Right Side of Machine
g018091