Lubrication; Greasing The Bearings, Bushings, And Pivots; Engine Maintenance; Engine Safety - Toro LT-F3000 Operator's Manual

Lubrication

Greasing the Bearings,
Bushings, and Pivots
Service Interval: Before each use or daily
Every 50 hours
Lubricate all grease fittings for the bearings and
bushings with No. 2 lithium grease. Lubricate the
1. – Grease every 50 hours

Engine Maintenance

Engine Safety

•
Shut off the engine before checking the oil or
adding oil to the crankcase.
•
Do not change the governor speed or overspeed
the engine.
bearings and bushings immediately after every
washing, regardless of the interval listed.
Replace any damaged grease fittings.
Important:
Use 1 pump of grease on the
height-of-cut adjusters and 3 pumps of grease on
all other grease fittings.
The grease fitting locations and quantities are as
follows:
Figure 43
2. – Grease daily
Checking the Engine
Overheat Warning System
Service Interval: Every 500 hours
36
g034909