Servicing The Air Cleaner - Toro LT-F3000 Operator's Manual

Figure 44
1. Temperature switch
1. Turn the ignition key to the ignition on position I.
2. Disconnect the red/blue wire terminal from the
engine-temperature switch.
3. Touch the metal terminal of this wire onto a
suitable earth point, ensuring that the metal
surfaces make good contact.
The horn sounds and the
engine-coolant-temperature-warning light illuminates
to confirm correct operation. If the system is
malfunctioning, make repairs before operating the
mower.

Servicing the Air Cleaner

Service Interval: Before each use or daily
Every 500 hours
Servicing the Primary Air Filter
Check the air-cleaner body for damage which could
cause an air leak. Replace if damaged. Check the
whole intake system for leaks, damage or loose hose
clamps.
Service the primary air-cleaner filter only when the
service indicator (Figure
the air filter before it is necessary only increases the
chance of dirt entering the engine when the filter is
removed.
Important:
Be sure that the cover is seated
correctly and seals with the air-cleaner body.
1. Check the filter-blockage indicator. If the
indicator is red, the air filter needs to be cleaned
or replaced (Figure
45) requires it. Changing
45).
2. Before removing the filter, use low pressure
g014437
air (40 psi, clean and dry) to help remove
large accumulations of debris packed between
outside of the filter and the canister. Avoid
using high-pressure air which could force
dirt through the filter into the intake tract.
Note:
This cleaning process prevents debris
from migrating into the intake when the filter is
removed.
1. Rubber outlet valve
2. Removable cover
3. Remove the cover from the air-cleaner body.
4. Remove and replace the filter
Cleaning of the used element is not
recommended due to the possibility of damage
to the filter media.
5. Inspect the new filter for shipping damage,
checking the sealing end of the filter and the
body. Do not use a damaged element.
6. Insert the new filter by applying pressure to the
outer rim of the element to seat it in the canister.
Do not apply pressure to the flexible center
of the filter.
7. Clean the dirt ejection port located in the
removable cover. Remove the rubber outlet
valve from the cover, clean the cavity and
replace the outlet valve.
37
Figure 45
Figure 46
3. Air filter
(Figure 46).
g014565
g022394