4
SETUP AND PROCEDURES BEFORE STARTING THE OPERATION
4 - 28
(b)
Connecting a cable to the spring clamp terminal block
The following explains connecting method of a cable to a spring clamp
terminal block.
For the stripping method of the cable end, refer to Section 3.1.4. in this
manual.
Use a recommended screwdriver or equivalent for connecting or
disconnecting cables. (Refer to Appendix. 5)
1)
Connecting the cable
Fully insert the cable into the correct opening with the open/close
button pressed by a slotted screwdriver.
When using a bar terminal, the cable can be inserted without pressing
the button.
Open/close button
2)
Disconnecting the cable
Keep pressing the open/close button by a slotted screwdriver until the
cable is completely pulled out.
Insertion hole
MELSEC-Q
4 - 28