Table of Contents
Advertisement
6 Getting Started
6.2 Assembly
✧
Press the cover of the battery compartment back into the housing and make sure it is in the correct
position.
NOTE on Battery Disposal
The battery used in this device contains lithium. It may only be replaced by qualified personnel and disposed
of by authorized recycling companies.
Do not dispose of the battery in the regular household waste.
The national and international regulations must be observed when disposing of the battery.
Information on battery life can be found in chapter 13.1.5.
6.2
Assembly
6.2.1
General Assembly Notes
SICAM Q100 is designed for panel flush mounting.
WARNING
Do not touch any live parts.
Non-observance may lead to death or serious injury.
✧
After installation of the device and wiring, close the control cabinet.
•
The installation site must be vibration-proof. The permitted ambient temperature must be observed (see
the technical data in chapter 13).
•
Operating the device outside the permitted operating temperature range can lead to measuring errors and
device failure.
•
The terminals are designed for wire cross-sections of 2.5 mm² max.
•
The device must not be exposed to condensation during operation.
•
Install the device in a location where it is not exposed to direct sunlight and strong temperature variations.
92
SICAM Q100, 7KG95xx, Device Manual
E50417-H1040-C522-A4, Edition 03.2018
Advertisement
Table of Contents
