Siemens Sinumerik 840D sl Programming Manual page 652

Oscillation
11.1 Asynchronous oscillation (OS, OSP1, OSP2, OST1, OST2, OSCTRL, OSNSC, OSE, OSB)
Significance
<axis>
OS
OSP1
OSP2
OST1
OST2
652
Name of oscillating axis
Activate/deactivate oscillation
Value: 1 Switch oscillation on
0 Switch oscillation off
Define position of reversal point 1
Define position of reversal point 2
Note:
If incremental movement is active, the position will be calculated incrementally
to the last corresponding reversal position programmed in the NC program.
Define stopping time in reversal point 1 in [s]
Define stopping time in reversal point 2 in [s]
-2 Interpolation continues without wait for exact stop
<value>:
-1 Wait for exact stop coarse
0 Wait for exact stop fine
>0 Wait for exact stop fine and then wait for specified stopping
time
Note:
The unit for the stopping time is identical to that of the
stopping time programmed with G4.
Programming Manual, 02/2011, 6FC5398-2BP40-1BA0
Job planning