Table of Contents
Advertisement
WARNING
CALIFORNIA
Proposition 65 Warning
The power cord on this product contains
lead, a chemical known to the State
of California to cause birth defects
or other reproductive harm. Wash
hands after handling.
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Introduction
This machine is designed to mix mortar, plaster,
fireproofing material, grout, and other small-grained
cement products. A vehicle equipped with an
appropriate pintle hitch or ball hitch can tow the
machine..
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com
for product safety and operation training materials,
accessory information, help finding a dealer, or to
register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Write the
numbers in the space provided.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
The DOT tire information is located on the side of
each tire. This information gives load and speed
ratings. Replacement tires should have the same or
better ratings.
Note:
The various machines in this manual have
different weights; refer to
ensure that the tires on your machine meet or exceed
the weight requirements of your machine.
2
Figure 1
Figure 2
Specifications (page 12)
Contact us at www.Toro.com.
Printed in the USA
All Rights Reserved
g028582
g000502
to
Advertisement
Table of Contents
