Table of Contents
Advertisement
7.
Release the drum latch and dump the drum;
refer to
Dumping the Drum (page
Using the Drum
DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum at any
time.
Dumping the Drum
Note:
When dumping a batch of material, leave the
motor running and the clutch in the O
rotating paddles help discharge the material.
1.
Align a wheelbarrow or similar container of
adequate capacity in the path of the drum
opening.
2.
Grasp the dump handle with your left hand
(Figure
28).
1. Dump handle (mix
position)
2. Drum latch (release
position)
Note:
When dumping a batch of material, align
a wheelbarrow or a similar container of adequate
capacity beneath the chute.
24).
position so the
N
Figure 28
3. Drum latch (locked
position)
4. Dump handle (dump
position)
3.
Lift the handle of the drum latch
4.
With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of
the drum
Note:
Allow the machine to completely
discharge the contents of the drum.
5.
Rotate the dump handle clockwise until the
drum latch locks the drum in the upright position
(Figure
28).
6.
After discharging a batch of material, clean the
drum; refer to
Note:
This step will clean the paddles and drum
between batches and prevent dried material
from forming, and contaminating the next batch
of material.
Cleaning the Drum
Important:
Do not strike on the drum with a
shovel, hammer, or any other device to loosen any
accumulated dried materials.
1.
Stop the rotation of the paddles by moving
the clutch lever to the O
Controlling the Paddles (page
2.
Move the motor O
position; refer to
12).
3.
Ensure that the drum is in the mix position
(upright); refer to
step 5.
4.
Spray the machine with water to remove any
accumulated material.
5.
Start the motor; refer to
21).
6.
Start the rotation of the paddles by moving
the clutch lever to the O
Controlling the Paddles (page
7.
Dump the drum; refer to
(page
24).
g028574
24
(Figure
28).
Cleaning the Drum (page
position; refer to
FF
21).
/O
switch to the O
N
FF
Motor O
/O
N
FF
Dumping the Drum (page
Starting the Motor (page
position; refer to
N
21).
Dumping the Drum
(Figure
28).
24).
FF
Switch (page
24),
Advertisement
Table of Contents
