Switching On/Off / Selecting A Heat Setting; Automatic Switch-Off; Styling - Straightening - Silvercrest SBHS 50 B1 Operating Instructions Manual

Switching on/off / Selecting a heat setting

■ After you have plugged the appliance into the mains, you can switch it on
with the level switch 6 and select the heat level:
– "0"
– "1"
– "2"
■ After you have selected a heat level, the respective LED 4/5 starts to flash,
indicating that the appliance is heating up .
As soon as the selected temperature is reached, the LED 4/5 lights up
permanently .

Automatic switch-off

This appliance is fitted with an automatic switch-off system . After 30 minutes,
the appliance will switch itself off automatically . After around 25 minutes, the
LED 4/5 that was lit last starts to flash to inform you that the appliance is
about to switch off automatically . If you want to continue using the appliance,
switch it off for a moment and then back on again .
NOTE
► The automatic switch-off is a safety function only and is not intended as a re-
placement for switching the appliance off properly using the level switch 6!
Styling – straightening
For straightening, the hair should be dry and free of styling products . This does
not apply to products designed to promote the straightening process or protect
the hair from the effects of heat .
The appliance is heated up to the desired level and the hair is combed and free
of knots .
■ Separate individual strands .
■ Twist a strand around the styling brush 2 and pull it down slowly (depending
on the type of hair) from the roots to the tips . While doing so, curl the styling
brush 2 inwards a little .
■ Proceed the same way with the other strands .
■ Once you are finished styling, turn the level switch 6 to "0" and pull out the
plug from the mains power socket .
■ 8 GB │ IE │ NI
│
The appliance is switched off, both LEDs 4/5 are off
for fine hair (the LED for fine hair (level 1) 5 flashes)
for thick hair (the LED for thick hair (level 2) 4 flashes)
SBHS 50 B1