Siemens SENTRON 7KN POWERCENTER 3000 Manual page 28

Installing, connecting, commissioning
4.1 Preparing installation
Procedure – mounting
Procedure - removal
1. Press the device downward until the lower DIN rail guide releases the device.
2. Swing the device away from the DIN rail.
3. Remove the device.
See also
Dimensional drawing of basic device (Page 81)
26
1. Place the DIN rail on the rear of the device.
Pay attention to the position of the springs of the
DIN rail clip.
2. Fasten the DIN rail clip with the 4 screws supplied.
3. Place the device on the DIN rail clip onto the DIN
rail from above.
If you position the device so that it is skewed, the
DIN rail clip will not engage.
4. Press the device downward onto the DIN rail until
the DIN rail clip engages below.
5. Check that the device fits closely on the DIN rail.
6. For vertical standard rail mounting: Mount a DIN
rail grounding clip below the device.
7KN POWERCENTER 3000
Manual, 10/2019, L1V30579222003-01