Table of Contents
Advertisement
Installation, relocation, storage, and connection
Do not install the product in any place other than specified.
Do not install the product in the following places or any place other than specified in this User's
Guide. Failure to follow this instruction may cause a fire.
A dusty place
A humid place such as near a boiler
A place exposed to direct sunlight
An unstable place
Do not use the product in an environment where corrosive gas is present
Do not install the product in a place subject to corrosive gases including sodium chloride, sulfur
dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, or ozone. Do not install the
product in an environment that contains dust, chemicals that accelerate corrosion such as
NaCl or sulfur, or conductive materials. Failure to follow this warning may cause the wiring on
the printed wiring board to short-circuit, leading to fire. If you have any questions, contact the
store where you purchased the product or a maintenance service company.
Do not apply any weight on the device when it is pulled out from the rack.
Do not apply force on the device when it is pulled out from the rack. Doing so cause the frames
to bend, which makes it impossible to be mounted on the rack. It also may cause the device to
fall, resulting in personal injury.
Do not get your fingers caught in the rails
When mounting/removing the product onto/from the rack, be careful to avoid getting your
fingers caught in the rails or cutting your fingers on the rails.
Do not attempt to connect or disconnect the interface cable while the power cord is
plugged into an outlet
Be sure to unplug the power cord from a power outlet before connecting/disconnecting any
interface cable to/from the product. If the product is off-powered but its power cord is plugged
to a power source, touching a cable or connector may cause an electric shock or a fire resulted
from a short circuit (except for hot-swappable device).
Do not drop the product.
Firmly hold the bottom of product when installing/removing to/from the rack. The rack rails do
not have any stopper or locking mechanism. If the device is fully pulled out from the rack, it
may fall resulting in personal injury.
Do not use any unauthorized interface cable.
Use only the interface cable specified for the product. Make sure the connector type and
connect with correct destination. Improper cable connection could cause electric shock or fire
due to short-circuit.
Also, observe the following precautions when handling or connecting the interface cable.
Do not use any damaged cable.
Do not step on the cable.
Do not place any object on the cable.
Do not modify, alter, nor repair the cable.
When disconnecting the InfiniBand cable, pull the latch release mechanism, hold the
connector portion, and pull the cable straight out.
Use the InfiniBand cable specified by NEC, and make sure the destination connector.
CAUTION
- 14 -
Advertisement
Table of Contents
