Dell DSS 1510 Owner's Manual page 83

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If applicable, disconnect the cables from expansion card(s).
4. Remove the expansion card riser.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
5. Remove the cooling shroud.
6. Keep the Phillips #2 screwdriver ready.
Steps
1. Disconnect the management network cable from the remote management port.
2. Loosen the two screws securing the remote management port card holder to the system board.
3. Pull the remote management port card up and toward the front of the system to disengage it from the connector and remove the
card from the chassis.
Figure 39. Removing the optional remote management port card
1. remote management port card holder
3. remote management port card
5. remote management port card connector on the system board
Next steps
1. Install the expansion card riser.
2. If applicable, connect the required power or data cables to the expansion card(s).
3. Install the cooling shroud.
4. If applicable, open the expansion card latch on the cooling shroud to support the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
Related tasks
Before working inside your system
Removing the expansion card riser
Removing the cooling shroud
Installing the expansion card riser
2. remote management port
4. screw (2)
Installing and removing system components 83