Installing The Optional Remote Management Port Card - Dell DSS 1510 Owner's Manual

Installing the cooling shroud
After working inside your system

Installing the optional remote management port card

Related reference
Safety instructions
Installing the optional remote management port card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
4. If applicable, disconnect the cables from expansion card(s).
5. If applicable, remove the expansion card riser.
Steps
1. Align and insert the tabs on the remote management port card on the slots on the chassis wall.
2. Insert the remote management port card into the connector on the system board.
3. Tighten the screws to secure the remote management port card.
Figure 40. Installing the optional remote management port card
1. remote management port card holder
3. remote management port card
84 Installing and removing system components
2. remote management port
4. screw (2)