– Slot 2: Not available
– Slot 3: PCIe x16 (x8, x4, x1), full-height, half-length
• Type 4
– Slot 1: PCIe x16 (x8, x4, x1), full-height, half-length/full-height, full-length
– Slot 2: Not available
– Slot 3: ML2 x16 (x16, x8, x4, x1), full-height, half-length
• Type 5
– Slot 1: PCIe x16 (x16, x8, x4, x1), full-height, half-length/full-height, full-length
– Slot 2: PCIe x16 (x8, x4, x1), full-height, half-length/full-height, full-length
– Slot 3: PCIe x16 (x16, x8, x4, x1), full-height, half-length
PCIe slot 4 on the system board: PCIe x8 (x8, x1), low-profile
PCIe slots 5 and 6 on riser 2:
• Slot 5: PCIe x16 (x16, x8, x4, x1), full-height, half-length/full-height, full-length
• Slot 6: PCIe x16 (x16, x8, x4, x1), full-height, half-length/full-height, full-length
14
Rear 3.5-inch drive bays (2)
Used to install up to two 3.5-inch hot-swap drives on the rear of the server. The rear 3.5-inch drive bays are
available on some models.
The number of the installed drives in your server varies by model. The EMI integrity and cooling of the server
are protected by having all drive bays occupied. The vacant drive bays must be occupied by drive bay fillers
or drive fillers.
Rear view LEDs
The illustration in this section shows the LEDs on the rear of the server.
Figure 14. Rear view LEDs of the server
.
Chapter 2
Server components
29