Loading/Replacing The Media - Toshiba SL-5300 Series Owner's Manual

8. LOADING/REPLACING THE MEDIA

8. LOADING/REPLACING THE MEDIA
1. Do not touch the print head or around the print head, or you may get burned as the print head
becomes very hot during printing.
2. Do not touch the cutter blade, as this may cause injury.
3. Firmly hold the bottom of the label cassette when pulling it out. Failure to do this may cause the
label cassette to drop, resulting in injury.
CAUTION!
Do not push down or hit the print head, as this may cause a machine failure.
In this section how to load or replace the label is described. Please use TOSHIBA TEC-approved
labels only. For the label specification, refer to Section 2.1.
NOTES:
1. The label loading procedure differs according to the issue modes: Batch and Strip.
2. When purchasing the labels, contact the nearest TOSHIBA TEC service representative.
3. The loading procedure of receipt is same as that of the label. (Receipts are used in the Report and Reset
mode.)
1. Pull out the label cassette. See the label loading procedure displayed on the operation panel just
for your reference.
NOTE: When replacing the label, first cut the backing paper at the position of arrow A, remove the
backing paper stopper, move the media roll stopper to the right, and remove the label roll and
the backing paper roll from the label cassette.
Caution symbol for the cutter blade
(Please refer to WARNING!)
Print Head Block
Label Cassette
Backing Paper Stopper
WARNING!
A
8- 1
EO1-31009
8. LOADING/REPLACING THE MEDIA
Label Cassette