Dll (Lan Master/Satellite System) Setting - Toshiba SL-5300 Series Owner's Manual

14. PROGRAMMING MODE
Procedure
Item
Setting to OFF Line
Designating the scale to a
master and setting the IP
address
Designating the scale to a
satellite and setting the IP
address

14.19 DLL (LAN Master/Satellite System) Setting

When the scale is designated to the master, you can download the data to the satellite using the LAN.
(Refer to Section 14.18.)
The following screen will appear when the [DLL (LAN)] key of the Programming Mode Main Menu is
touched. Select the item to be downloaded and destination satellite.
Item key
Scale ID# key
ID02 –ID16
1. Touch the [OFF LINE] key.
2. Touch the [BACK] key.
3. Turn the power off and then on again according to the message.
1. Touch the [MASTER] key.
2. Touch the [BACK] key twice.
3. Turn the power off and then on again according to the message.
NOTE: When the scale is designated to a master, its IP address will
appear as ID01 (MASTER ID) automatically. Also, all of the satellites IP
addresses are automatically displayed.
1. Touch the [SATELLITE] key.
2. Input the IP address of the master scale.
3. Touch the IP address area (ID No. 1).
4. Touch the [BACK] key twice.
5. Turn the power off and then on again according to the message.
NOTE: When the scale is designated to a satellite, set the master
scale's IP address only.
ALL key
14-56
14.19 DLL (LAN Master/Satellite System) Setting
Procedure
OPEN key
DLL key
EO1-31009
CLOSE key
ALL SATELLITES key
CANCEL key
DISCONNECT key