Toshiba SL-5300 Series Owner's Manual page 220

24. ERROR MESSAGE TABLE
(Continued)
Error Message
Paper Feed Error
occurs.
Please adjust print
position.
Abnormal Head
Temp. is detected.
Abnormal Head
source is detected.
Unit Price is over the
limit.
The number of letters
is over the limit.
Format Read Error
occurs.
Format No. Error
occurs.
Press C key and set
correct Format,
please.
Appointed code is not
found.
Flash Rom Write Error
occurs.
Flash Rom Format
Error occurs.
No data is found.
The File is full.
There is no File of
PLU Field information.
This position is over
the frame.
MC Access Error
occurs.
This Format is not
selectable.
Folder cannot be
made.
Cause
The label format doesn't match the label
cassette or the print start position is
incorrect.
Thermal head temperature is over the
limit.
The power source for thermal head is
incorrect because of the circuit failure.
The Number of digits of the Unit Price is
over the maximum limit.
The Number of characters is over the
maximum limit.
The selected label format cannot be read
because of incorrect memory.
Because unavailable Format No. is
selected, the label format cannot read.
The selected code doesn't exist in the file.
Because of Flash-ROM failure, the
selected data cannot be written into the
Flash-ROM.
Because of Flash-ROM failure, data in the
Flash-ROM cannot be erased.
The selected item and data are not found
in the memory.
There is no space for saving the selected
data.
Because the PLU file is damaged, the
selected PLU cannot be called.
The selected position is out of the label
format area.
File and folder information cannot be
taken from the memory card.
The selected label format Number doesn't
exist.
The Number of digits of folder name is
over 8 digits.
Re-load the label.
Re-program the label format.
Leave the scale on for 3 minutes or
more, and then perform operations.
Turn off the power, and then ask your
authorized TOSHIBA TEC
representative.
Re-program the Unit Price so that the
Number of digits is within the maximum
limit.
Re-program the name so that the
Number of characters is within the
maximum limit.
Reset the label format in the label format
setting mode.
Re-program a correct label format
Number.
Enter a correct code which exists in the
file.
Turn off the power, and then ask your
authorized TOSHIBA TEC
representative.
Turn off the power, and then ask your
authorized TOSHIBA TEC
representative.
Enter a correct Code Number.
Delete unnecessary PLU data from the
file.
Delete this PLU file, and then re-program
the PLU field.
Re-program the label format so that the
print position is within the format.
Turn off the power, and then ask your
authorized TOSHIBA TEC
representative.
Specify the label format Number which is
available for this scale.
Set the folder name with up to 8 digits of
alphabets and numeric.
24- 2
EO1-31009
24. ERROR MESSAGE TABLE
Solution