User Interface Menus - ABB PME120-AI Service Instruction

PME120-AI / PME120-AN (Contrac) ELECTRICAL ROTARY ACTUATOR | SEI/PME120-EN REV. A

User interface menus

Figure 45: Troubleshooting related menus in the user interface (digitally manipulated screen shot)
The following table represents the first 2 menu levels (see also Figure 45 on page 35) of the graphical user interface as far as the
troubleshooting is concerned. Some of the subjects in Troubleshooting on page 27 refer to the user interface.
Use the numbering in table 5 to facilitate the navigation. The user interface software does not use any numbering in the menus.
A Operate
A 1 Positioner
A 2 Controller
B Diagnosis
B 1 Status
B 2 Alarms / Failures
B 3 Maintenance
B 4 Load
C Configure
C 1 General
C 2 Operation
C 3 End positioner
C 4 Input / Output
C 5 Monitoring
C 6 Controller
C 7 Actuator specific data
C 8 Data overview
D Service
D 1 Initial setting
D 2 Test
D 3 Signal simulation
D 4 Calibration of analog output
35