Installation Of Devicenet I/O, Gateways And Encoder Interface Units, Irc5 - ABB IRC5 Product Manual

2.9.4 Installation of DeviceNet I/O, Gateways and encoder interface units, IRC5

Location
The DeviceNet I/O units, Gateway or encoder interface units to be installed are
shown in the illustration below.
xx0600003256
A
B
C
Required equipment
Equipment
DeviceNet I/O units, Gateways or en-
coder interface units
Application manual - DeviceNet Mas-
ter/Slave
Circuit diagram
Fitting
The procedure below details how to fit the units.
1
2
3
4
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: AB
2.9.4 Installation of DeviceNet I/O, Gateways and encoder interface units, IRC5
A
C
I/O units, Gateways or Encoder interface units
Mounting rail
Connection terminal XT31
Action
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more in-
formation, see Electrical safety on page
Fit the DeviceNetI/O unit by snapping it
onto the mounting rail.
Connect the DC supply to the board.
Connect wires to the inputs and output
connectors as required.
© Copyright 2007-2024 ABB. All rights reserved.
2 Installation and commissioning
B
Article number
3HAC050992-001
See Circuit diagrams on
page 273.
Note/Illustration
35.
Described in the Application manual for
the respective busses.
Note
123