ABB IRC5 Product Manual page 132

2 Installation and commissioning
2.9.6 Installing the EPS board DSQC 646 for Electronic Position Switches
Continued
12
132
Action
Connect signal cables to the plug con-
tact, which is then connected to the I/O
connector of the EPS board.
• Connect a power supply, 24 V to
pin 1 and 0 V to pin 2. Check with
a voltmeter that the voltage is 24
V between pin 1 and 2 on the
Phoenix connector.
• Connect the output signals from
the EPS board (pin 3-12).
• Connect the sync switch signals
to pin 13 and 14. If dual channel
wiring is not used, connect only
pin 14.
© Copyright 2007-2024 ABB. All rights reserved.
Note/illustration
A
xx0600003209
• A: I/O Connector
• B: Plug contact
• C: Power supply
• D: 5 safe outputs (10 signals)
• E: Sync switch (dual signal)
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: AB
C
B
1
D
14
E