ABB IRC5 Product Manual page 128

2 Installation and commissioning
2.9.6 Installing the EPS board DSQC 646 for Electronic Position Switches
Continued
3
4
5
Continues on next page
128
Action
If not already in place, fit the EMC strips
on the EPS board.
Connect the short SMB cable and both
Ethernet cables to the EPS board before
mounting the board. These connections
may be difficult to reach once the board
is mounted.
The two Ethernet connectors on the EPS
board are interchangeable (it does not
matter which is connected to the main
computer and which is connected to the
axis computer).
Remove the attachment screws of the
axis computer. Lift out the axis computer
so that the EPS board can be fitted be-
hind the axis computer.
© Copyright 2007-2024 ABB. All rights reserved.
Note/illustration
A
xx0700000087
xx0600003303
xx0900000030
• A: axis computer
• B: attachment screws
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: AB