ABB IRC5 Product Manual page 46

2 Installation and commissioning
2.3.1 Unpacking the controller
Continued
Weight of controller
The table below shows the weight for the IRC5 controller:
Controller
PMC small
PMC large
Weight of additional equipment
The table below shows the weight for equipment used with the IRC5 Panel Mounted
Controller:
Equipment
Transformer
Inductor
Protection class
The table below shows the protection classes for the IRC5 controller and the
FlexPendant:
Equipment
IRC5 Panel Mounted Controller
FlexPendant
The Panel Mounted Controller modules must be mounted in a water-proof and
air-proof cabinet. Internal cooling is recommended but if that is not possible, a
filter shall be used. When used in industrial environment, the cabinet should fulfill
IP54. When used in foundry environment, the cabinet should fulfill IP67.
Continues on next page
46
Note
The humidity conditions shall apply with the environmental conditions EN
60721-3-3, climatic class 3K3. For temperatures 0-30°C, the relative humidity
must not exceed 85%. For temperatures exceeding 30°C, the absolute humidity
must not exceed 25g/m
If the environmental conditions in EN 60721-3-3, climatic class 3K3, are not
possible to meet at the installation site, desiccant bags can be placed inside the
controller to achieve corresponding conditions. The desiccant bags must be
replaced regularly to maintain approved operating conditions.
© Copyright 2007-2024 ABB. All rights reserved.
3
.
Part
Complete controller
Control module
Drive module
Complete controller
Control module
Drive module
Product manual - IRC5 Panel Mounted Controller
Weight
max. 40 kg
12 kg
22.5 kg
max. 60 kg
14 kg
40 kg
Weight
13-51 kg
5.2 kg
Protection class
IP20
IP54
3HAC047137-001 Revision: AB