Huawei NE05E Series Quick Installation Manual page 26

3
Assembling OT Terminals
Material: OT terminals (ring terminals) , heat-shrinkable tube and cable.
Strip a part of the jacket off the cable to expose the
conductor with a length of L1.
L1 = 23 mm to 25 mm
L1
CAUTION
When stripping the jacket off the cable, do not
damage the metal conductor of the cable.
Lead the cable through the heat-shrinkable tube,
and then place the contact terminal on the
exposed conductor.
B: OT terminals
CAUTION
•Close contact between the contact terminal and the end of
the jacket of the cable is required.
•When placing the contact terminal on the conductor
closely to the end of the jacket, ensure that the L2 part of
the conductor which sticks out of the contact terminal
cannot exceed 2 mm.
Conductor
C: power cable
insulation layer
A: heat-shrinkable
Press the end of the contact terminal on the
conductor by using the crimping tool.
Heat the heat-shrinkable tube by using a heat gun.
CAUTION
Do not overheat the heat shrink tube.
Otherwise, the insulation layer may be
damaged.
23
Heat gun