Huawei USG6000 Series Hardware Manual page 162

HUAWEI USG6000 Unified Security Gateway
Hardware Guide
The four GE RJ45 ports on this card can be used as Layer 3 ports.
Panel
Figure 1-71
Figure 1-71 4GE-BYPASS card panel
Name
Ports 0 and 1 (RJ45)
Ports 2 and 3 (RJ45)
LINK indicator (green)
ACT indicator (yellow)
Indicator 0-1 (green)
Indicator 2-3 (green)
Issue 03 (2015-01-26)
availability. After the USG recovers, the Layer 2 electrical link bypass works in the
working state.
illustrates the appearance of the 4GE-BYPASS card panel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Two 10/100/1000M autosensing Ethernet electrical ports
numbered 0 and 1. The two ports form a bypass port pair.
When working as the upstream and downstream ports on the
same Layer 2 link, the two ports form a bypass link. When
working at Layer 3, the two ports are both standard RJ45 ports.
Two 10/100/1000M autosensing Ethernet electrical ports
numbered 2 and 3. The two ports form a bypass port pair.
When working as the upstream and downstream ports on the
same Layer 2 link, the two ports form a bypass link. When
working at Layer 3, the two ports are both standard RJ45 ports.

Off: The link is disconnected.
 Steady on: The link is connected.

Blink: Data is being sent or received.

Off: No data is being sent or received.
Status indicator of the Layer 2 bypass link formed by GE0 and
GE1
 Steady on: The card is powered on. The bypass formed by
GE0 and GE1 is in protection state.

Blink: The card is powered on. The bypass formed by GE0
and GE1 is in working state.
 Off: The card is powered off. The bypass formed by GE0
and GE1 is in protection state.
Status indicator of the Layer 2 bypass link formed by GE2 and
GE3
 Steady on: The card is powered on. The bypass formed by
GE2 and GE3 is in protection state.
 Blink: The card is powered on. The bypass formed by GE2
1 Hardware Overview
152