LG ARNH963K2A2 Installation Manual page 25

Installation of Wired Remote Controller
1. Please fix tightly using provided screw after
placing remote controller setup board on the
place where you like to setup.
- Mount on a flat surface do not torque or bend
the PCB board while installing.
- If the wired remote controller is being attached
to a handy box, mount the wired remote
controller subbase with threaded screws to the
box.
2. Wired remote controller cable termination
options.
- The cable may be connected to the wired
remote controller from the rear, the top edge
and the right side of the subbase.
- If using the top right corner entry points, snap
off the plastic tab with needle nose pliers as
shown.
① Rear entry point
② Top entry
③ Right side entry
3. Please fix remote controller body to the
subbase attached to the surface of the wall,
Snap the comptroller body onto the subbase
by gently pressing along the bottom edge of
the device.
Two remove the controller body from the
subbase, insert a small flat blade screw
driver into the two slots along the bottom
edge of the subbase and gently turn
clockwise to bend the keeping tabs.
Concurrently gently pull on the bottom of
the controller body and rotate up.
- Please individually separate one at a time.
- Please be careful not to damage the inside
components when separating.
Accessories Installation
2
3
1
<Wire guide grooves>
<Connecting order>
Wall
Side
<Separating order>
Wall
Side
Hydro Kit Installation Manual 25
2
3
Wall
Side
Wall
Side