Playing Back Cds; Loading Cds; Playing Back A Cd - JVC PC-XC370 Instructions Manual

Playing Back CDs

NOTES ON CD-R AND CD-RW DISCS
• This unit can play back CD-R and CD-RW discs as well as
conventional audio CDs. However, note that a CD-R or a
CD-RW disc must be "finalized" so that it can be played
back on this unit correctly.
"Finalization" is a process to create a TOC (Table Of
Contents) section on a recorded disc. If you attempt to play
back a non-finalized disc, especially a non-finalized CD-
RW disc on this unit, malfunction may occur since no TOC
section exists on the disc.
• When a non-finalized CD-R or a CD-RW disc is loaded or
ejected, it may take a considerably long time, but this is not
a malfunction.
• This unit does not support track skipping function. Even if
a CD-R disc or a CD-RW disc is created so that some
tracks are skipped during playback, this unit also plays
such tracks.

Loading CDs

1 Press CD1 0, CD2 0, or
CD3 0 for the disc tray you
want to load a CD onto.
The unit automatically turns on, and
the selected disc tray comes out.
2 Place a disc correctly on the circle of the disc
tray, with its label side up.
CORRECT
• When using a CD single (8 cm), place it on the inner
circle of the disc tray.
3 Press the same button you
have pressed in step 1.
The disc tray closes.
4 Repeat steps 1 to 3 to place
other CDs.
INCORRECT
– 13 –
Using 0 ALL
When you press 0 ALL, three disc trays
come out at the same time.
Place a disc on the disc tray 3, manually
push the disc tray 3 into the unit, place a
disc on the disc tray 2, manually push
the disc tray 2 into the unit, and then
place a disc on the disc tray 1. Finally
press 0 ALL to close the compartment.
About the disc indicators
Each disc indicator corresponds to the disc tray of the same
number.
Disc marker
1
Disc number
• The disc marker indicates that the corresponding disc is
currently selected.
• The disc indicator goes off when the unit has detected that
there is no CD on the corresponding disc tray.

Playing back a CD

On the unit, press 3 CD1, 3 CD2 or
3 CD3, corresponding to the disc you
want to play.
Alternatively, press CD 6, and the
disc currently selected starts to play.
On the remote control, press one of
the CD playback buttons (1 to 3)
corresponding to the disc you want to
play.
Track
number
2 3
Disc indicator
Elapsed playing
time