Troubleshooting; Specifications - JVC PC-XC370 Instructions Manual

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Symptom
No sound is heard.
Power cannot be turned on.
No sound from the speakers.
The disc does not play.
The disc sound is discontinuous.
Hard to listen to broadcasts because of
noise.
Tape playback sound is at a very low level.
Impossible to record on a tape.
Timer operation does not start.
Unable to operate the unit with the remote
control.

Specifications

Amplifier section
Output power
5 W per channel, min. RMS, driven into 3 Ω at 1 kHz with no
more than 10% total harmonic distortion.
Audio input sensitivity/Impedance (at 1 kHz)
AUX: 1 000 mV/47 kΩ
Speakers/Impedance: 3 Ω - 8 Ω
Tuner section
FM tuning range: 87.5 MHz - 108.0 MHz
AM tuning range: 530 kHz - 1 710 kHz
CD player section
CD capacity: 3 CDs
Dynamic range: 60 dB
Signal-to-noise ratio: 75 dB
Wow and flutter: Immeasurable
Cassette deck section
Frequency response: 50 Hz - 10 000 Hz
Wow and flutter: 0.2% (WRMS)
Cause
Connections are incorrect or loose.
The power cord is unplugged.
Headphones are connected.
The disc is placed upside down.
The disc is scratched or dirty.
Antenna orientation is not correct.
The heads are dirty.
Small tabs on the back of the cassette are
removed.
The current time is not set correctly.
• The path between the remote control and
the remote sensor on the unit is blocked.
• The batteries are exhausted.
General
Power requirements:
Power consumption:
Dimensions (approx.):
Mass (approx.):
Supplied accessories
See page 6.
Speaker section
Type:
Speaker units:
Woofer:
Tweeter:
Power handling capacity:5 W
Impedance:
Frequency range:
Dimensions (approx.):
Mass (approx.):
–22 –
Action
Check all connections and make
corrections. (See pages 6 and 7.)
Connect the power cord.
Disconnect the headphones.
Place the disc with the label side up.
Clean or replace the disc. (See page 21.)
Readjust the antenna. (See page 12.)
Clean the heads. (See page 21.)
Cover the holes with adhesive tape.
Set the built-in clock correctly.
• Remove the obstruction.
• Replace the batteries.
AC 120 V , 60 Hz
DC 12 V ("R20/D(13F)" batteries (8))
External DC 12 V (car battery via
optional CA-R120 car adapter)
25 W (at operation)
3 W (on standby)
267 mm x 298 mm x 259 mm (W/H/D)
9 3 1
(10 / in. x 11 / in. x 10 / in.)
16 4 4
4.5 kg (9.9 lbs)
2-way bass-reflex type
12 cm (4 3 / in.) cone x 1
4
5 cm (2 in.) cone x 1
3 Ω
50 Hz - 18 000 Hz
193 mm x 289 mm x 254 mm (W/H/D)
5 7
(7 / in. x 11 / in. x 10 in.)
8 16
1.6 kg (3.6 lbs) each