Table of Contents
Advertisement
1. Exit-side lockout—reset light
2. Exit-side lockout—drill-enabled light
3. Receiver-battery-status light
4. Engine—start
5. Press down to stop the engine; pull up to start the engine.
6. Reset Zap-Alert system
7. Zap-Alert system triggered
8. Unlock exit-side lockout
9. Reset exit-side lockout
10. Engage drive movement and setup functions
11. Engage drill carriage movement and other drill functions
12. Work lights—On
13. Work lights
125-6112
14. Work lights—Off
15. Press and hold to increase engine speed.
16. Engine speed
17. Press and hold to decrease engine speed.
18. Mode I—left trigger released, extends pipe gripper toward
drill frame; left trigger pressed, opens lower wrench. Mode
II—spin drill spindle clockwise.
19. Mode I—left trigger released, extends pipe gripper toward
pipe holder; left trigger pressed, closes lower wrench. Mode
II—spin drill spindle counterclockwise.
20. Mode I—left trigger released, lowers pipe elevator; left trigger
pressed, opens upper wrench. Mode II—left trigger released,
extends pipe gripper toward drill frame; left trigger pressed,
opens upper wrench.
21. Mode I—left trigger released, raises pipe elevator; left trigger
pressed, closes upper wrench. Mode II—left trigger released,
extends pipe gripper toward pipe holder; left trigger pressed,
closes upper wrench.
22. With trigger released, rock forward to rotate pipe loader
toward pipe cam, rock backward to rotate pipe loader toward
drill frame.
23. With trigger released, upper button closes pipe gripper, lower
button opens pipe gripper.
24. With trigger pressed, rock forward to rotate the upper wrench
counterclockwise to loosen a joint; rock rearward to rotate the
upper wrench clockwise to tighten a joint.
25. With trigger pressed, press front or rear button to resume
the previously set auto-drill speed; press and hold the front
button to increase the auto-drill speed; press and hold the
rear button to decrease the auto-drill speed.
17
Advertisement
Table of Contents
