Toro 2024 Operator's Manual page 67

1. Oil-fill cap
B. Install the oil fill cap and the dipstick.
Changing the Engine-Oil Filter
Service Interval: Every 250 hours
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Open the front hood.
3. Align a drain pan or several rags under the oil filter and
the oil-filter adapter
1. Oil-filter adapter
4. Rotate the oil filter counterclockwise and remove the
oil filter (Figure 86).
Note: Discard the oil filter.
5. Using a clean rag, wipe clean the surface of the oil-filter
adapter where the oil filter seats with a clean rag.
6. Fill the new oil filter with the specified-engine oil.
7. Apply a thin layer of the specified-engine oil to the seal
of the oil filter.
1
Figure 85
(Figure 86).
Figure 86
2. Oil filter
8. Align the oil filter to the oil-filter adapter and rotate
it clockwise until the seal of the oil filter contacts the
oil-filter adapter
Note: Do not use an oil filter strap wrench to install
the new oil filter. The wrench can dent an oil filter and
therefore cause a leak.
9. Hand tighten the oil filter an additional 1/2 turn
(Figure
G021582
10. Remove the oil pan or rags you placed in step
dispose of the used oil according to local codes.
Changing the Engine Oil
Service Interval: Every 250 hours
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Remove the drain plug
1. Engine-oil drain plug
3. Clean the threads on the drain plug and apply 3 layers
of PTFE sealing tape.
4. Drain the oil into a drain pan.
5. When the oil stops, install the drain plug.
6. Change the engine-oil filter; refer to
Engine-Oil Filter (page
7. Install the drain plug onto the drain fitting
8. Remove the oil-fill cap from the filler neck by pulling
the cap upward.
67
(Figure 86).
86).
(Figure 87).
Figure 87
67).
3 and
Changing the
(Figure 87).