7. Store the cylinder lock next to the anti-freeze tank
(Figure
63).
Figure 63
1. Location behind the rear of the pipe holder
Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease
immediately after every washing).
Grease type: General-purpose grease.
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting.
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Lift cylinder (drill/carriage side; lower grease fitting is behind
60
Figure 64
the track roller)