3
2
1
Figure 105
1. Coolant level (at the
bottom of the filler neck)
2. Filler neck
4. Install the radiator cap
5. Fill the coolant reservoir with coolant until it is full.
6. Install the coolant reservoir cap.
7. Start the engine and run it at half throttle for 5 minutes.
8. Stop the engine and remove the key.
9. Wait 30 minutes, then check the fluid level in the
coolant reservoir. If it is low, add coolant.
G022028
3. Coolant (50/50 ethylene
glycol and water or
equivalent)
(Figure
101).
Belt Maintenance
Servicing the Engine-Drive
Belt
WARNING
Contacting a rotating belt can cause serious injury
or death.
Stop the engine and remove the ignition key before
working near belts.
Checking the Condition of the Belt
Service Interval: Every 250 hours
1. Park the machine on a level surface, stop the engine,
and remove the ignition key.
2. Open the front hood.
3. Inspect the belt for cuts, cracks, loose cords, grease, oil,
twisting, or signs of abnormal wear
Note: Replace the belt if it is excessively worn or
damaged.
81
(Figure
106).