Insert Blender Jug - Silvercrest MONSIEUR CUISINE EDITION PLUS Operating Instructions Manual

In order to remove the blade assembly 29,
proceed as follows:
1. Position the blender jug 5 horizontally.
2. Press the unlocking lever 37
on the underside of the blender
jug 5 so that it points to the
open lock symbol.
3. Pull out the blade assembly 29 carefully
towards the top.
In order to insert the blade assembly 29,
proceed as follows:
4. Position the blender jug 5 horizontally.
5. Insert the blade assembly 29 from the
top.
Please take note that the two cams at
the bottom of the blade assembly 29
must be pushed through the two recess-
es in the underside of the blender jug 5.
CAUTION:
Ensure that the seal 28 for the blade as-
sembly 29 is positioned correctly, since
otherwise the content may escape.
6. In order to lock the blade as-
sembly 29, move the unlock-
ing lever 37 on the underside
of the blender jug 5 so that it
points to the closed lock symbol.
20 GB
37
NOTE: chop large pieces into smaller ones
with an edge length of approx. 3 - 4 cm.
Otherwise larger pieces might get stuck in
the blades.

10.4 Insert blender jug

1. Place the blender jug 5 into the socket 9.
2. Press the blender jug 5 downwards
gently until the flower-shaped hub of the
blade assembly 29 engages with the
blade socket 10.
NOTES:
• If the blender jug 5 cannot be pressed
downwards, you need to "wobble" it
slightly so that the flower-shaped hub of
the blade assembly 29 in the blender
jug 5 engages with the blade sock-
et 10.
• Should the blender jug 5 not be posi-
tioned correctly, a safety mechanism
prevents the functioning of the device.