Installing And Uninstalling The Utility Package; Handling Precautions - Mitsubishi Electric MELSEC Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-DA)

5.2 Installing and Uninstalling the Utility Package

For how to install or uninstall the utility package, refer to "Method of installing the
MELSOFT Series" included in the utility package.

5.2.1 Handling precautions

The following explains the precautions on using the GX Configurator-DA.
(1)
(2)
(3)
(4)
(5)
5 - 2
For safety
Since GX Configurator-DA is add-in software for GX Developer, read "Safety
Precautions" and the basic operating procedures in the GX Developer Operating
Manual.
About installation
GX Configurator-DA is add-in software for GX Developer Version 4 or later.
Therefore, GX Configurator-DA must be installed on the personal computer that
has already GX Developer Version 4 or later installed.
Screen error of Intelligent function module utility
Insufficient system resource may cause the screen to be displayed
inappropriately while using the Intelligent function module utility. If this occurs,
close the Intelligent function module utility, GX Developer (program, comments,
etc.), and other applications, and then start GX Developer and Intelligent function
module utility again.
To start the Intelligent function module utility
(a) In GX Developer, select "QCPU (Q mode)" for programmable controller
series and specify a project.
If any programmable controller series other than "QCPU (Q mode)" is
selected, or if no project is specified, the Intelligent function module utility will
not start.
(b) Multiple Intelligent function module utilities can be started.
However, [Open parameters] and [Save parameters] operations under
[Intelligent function module parameter] are allowed for one Intelligent
function module utility only. Only the [Monitor/test] operation is allowed for
the other utilities.
Switching between two or more Intelligent function module utilities
When two or more Intelligent function module utility screens cannot be displayed
side by side, select a screen to be displayed on the top of others using the task
bar.
MELSEC-Q
5
5 - 2