Mitsubishi Electric MELSEC Q Series User Manual page 103

5 UTILITY PACKAGE (GX Configurator-DA)
5 - 24
Analog/Digital conversion: Select a conversion type shown below for confirming
Analog value: <When converted to a digital value>
<When converted to an analog value>
Digital value: <When converted to a digital value>
<When converted to an analog value>
POINT
 The offset value is the analog output value (voltage or current) when a digital
entry value of 0 is set from the programmable controller CPU.
 The gain value is the analog value (voltage or current) output when the digital
input value set from the programmable controller CPU is as follows:
12000 (When User range setting 1 to 3 are selected)
(3) Explanation of screen command buttons
Range setting
Conversion
the correspondence between an analog value and a
digital value caused by the conversion characteristic.
 Digital
Analog
 Analog
Digital
Enter an analog value to be converted to a digital value
The analog value converted from a digital value is displayed.
The digital value corresponding to an entered analog value is
displayed.
Enter a digital value to be converted to an analog value.
The entered offset/gain value is determined, and the I/O
characteristic diagram is updated.
Conversion for the entered value is performed.
MELSEC-Q
5 - 24