Replacing The Steering Cables - Husqvarna 967187001 Workshop Manual

Repair Work

7.1 Replacing the Steering Cables

1
1
Loosen the rear fastening of the steering
cables (1).
2
Remove the frame cover by loosening the screws.
3 pcs screws:
3
Make a note of how the cable is laid out. Loosen
the front attachment (8) of the steering cables at
the steering chain (12), loosen the steering cable
wheels (7) and pull the steering cables out through
the frame.
34
English –
8
7
Note.
If the old cables are whole, the new ones can be
attached to them as they are drawn out through
the frame. The new cables will then automatically
follow the correct route.
4
Ensure that the steering wheel is in the center
position when the rear wheels are centered. Re-
set the chain on the steering column's sprocket or
adjust the rear fixture (1) for the steering cables as
needed.
Hold the cables with e.g. an adjustable wrench so
they do not twist.
The wire tension must be checked after fitting the
new wires.
12