Replacing The Pendulum Shaft Bushings; Assembling The Pendulum Shaft - Husqvarna 967187001 Workshop Manual

Repair Work
7.8 Replacing the Pendulum Shaft
Bushings
When the pendulum shaft has been removed
(follow "7.6 Removing the pendulum shaft"), the
1
bushings in the rear frame must be changed.
Remove the bushings (1), (2) one from each
direction.
2
New bushings are fitted with the mandrel, refer to
"3 Special tools".
535 41 32-02
The bushings must be initially lubricated with a
lithium-based grease.
It is important that the outer bushing's outer edge
is on the same level as the beveled edge of the
hole.

7.9 Assembling the Pendulum Shaft

3
1
1
Slide the washer (2) on the pendulum shaft with
2
the beveled edge against the fork (1) of the
pendulum shaft.
2
Grease the shaft and assemble it in the front
frame.
3
Slide the ring (3) on from behind and screw in the
screw.
4
4
Roll the rear carriage forward and fit it into the fork
of the pendulum shaft.
41
English –