Installation Mode; Installation Procedure - Huawei IPE Series Installation Manual

IPE
Installation Guide
Tool
Black cross recessed
round head screw

2.2 Installation Mode

This section describes how to install the box IPC in the shield and fix it to the place required
by the customer. The installation method is simple. For details about the installation procedure,
see the following descriptions.
The wall where the bracket is installed must be able to bear at least three times of the total
weight of the bracket and the IPC.

2.3 Installation Procedure

Step 1 Install the box IPC on the mounting block. Use the Phillips screwdriver to fasten two black
screws onto the IPC, as shown in Figure 2-1.
Figure 2-1 Installing the IPC onto the mounting block
Mounting block
Step 2 Take out the installation plate from the shield. Adjust the IPC lens so that the front-most end
is 10 mm above the installation plate, as shown in Figure 2-2. Then, use the Phillips
screwdriver to fasten screws of the shield onto the installation plate.
Issue 03 (2013-02-28)
Appearance
CAUTION
Black screw
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
2 Installing the Housing of a Bo x IPC
Remark
4