Huawei IPE Series Installation Manual page 34

IPE
Installation Guide
Step 7 Rotate the module clockwise for about five degrees to install the module inside the lower
cover. Use a Philips screwdriver to fasten three black screws that are removed in Step 2, as
shown in Figure 5-6. (Spare screws are available in the accessory kit.)
Figure 5-6 Fastening screws
Step 8 Connect the video cable to the second video port. Check the video, adjust the lens angle, focus,
and viewing angle in the horizontal and vertical directions, and insert the SD card, as shown
in Figure 5-7.
Issue 03 (2013-02-28)
NOTE

If the top cabling mode is used, route the multi-connector cable through the 30 mm cable outlet on
the top.

If the side cabling mode is used, route the multi-connector cable through the side cable outlet of the
lower cover.
Side cabling
Multi-connector cable
NOTE
If the module is found loose after the video adjustment is complete, use a flat -head screwdriver to fasten
the screws on the module again.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd
Top cabling
Three black screws
5 Installing a Vandal-Proof Do me IPC
27