Test - Canon imageRUNNER ADVANCE C5500 Series Service Manual

TEST

■ PG
COPIER > TEST > PG
TYPE 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
TXPH 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
THRU 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
DENS-Y 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Test print
To execute the test print.
At problem analysis
Enter the setting value, and then press OK key.
Test print is executed.
Be sure to set the value back to 0 after the test print output.
0 to 100
0: Image from CCD (normal print)
1 to 3: For R&D use
4: 16 gradations
5: Whole-area halftone image
6: Grid
7 to 9: For R&D use
10: MCYBk horizontal stripes
11: For R&D use
12: YMCBk 64 gradations
13: For R&D use
14: Full color 16 gradations
15 to 100: For R&D use
0
Setting of test print image mode
To set the image mode at the time of test print output.
This mode is enabled for test print only.
At problem analysis
Enter the setting value, and then press OK key.
0 to 9
0: 600 dpi error diffusion (no trailing edge correction of Bk), 1: "Gradation" screen (no trailing edge
correction of Bk), 2: "Resolution" screen (no trailing edge correction of Bk), 3 to 4: None, 5: 600
dpi error diffusion (with trailing edge correction of Bk), 6: "Resolution" screen (with trailing edge
correction of Bk), 7: 1200 dpi error diffusion (no trailing edge correction of Bk), 8: 1200 dpi error
diffusion (with trailing edge correction of Bk), 9: "Gradation" screen (with trailing edge correction
of Bk)
Set image correct table use: test print
To set whether to use the image correction table at the time of test print output.
At problem analysis
Enter the setting value, and then press OK key.
0 to 2
0: "Auto Adjust Gradation": ON, "Auto Correct Full Color": OFF
1: "Auto Adjust Gradation": OFF, "Auto Correct Full Color": OFF
2: "Auto Adjust Gradation": ON, "Auto Correct Full Color": ON
Adj of Y-color density at test print
To adjust Y-color density when performing test print (TYPE = 5).
As the value is larger, the image gets darker.
At test print (TYPE = 5)
Enter the setting value, and then press OK key.
0 to 255
1033
8. Service Mode